You might have encountered problems with your Linksys Velop router if you use the internet regularly. There are many ways that you might have tried different troubleshooting methods to resolve those problems. Did you know there was a single solution for every problem with your Linksys Velop router? Yes, a factory reset Linksys velop can restore factory default settings to your router device.
You will get a new device with almost all the software features. After you reset Linksys Velop router you can reconfigure it so that you can continue browsing the internet seamlessly. If you have issues with internet access or device performance, a device reset can help. Simply put, the reset process will allow you to restore your router to a working condition. This blog contains information about how to reset Linksys Velop router.
Ways You Can Do a Factory Reset Linksys Velop
You can reset your router and make it ready for use again in one of two ways. These are:
- Use the physical RESET button
- Use the wizard for web-based setup
Use the Button to Manually Reset
You can reset your Linksys Velop router manually or by using the physical reset button. To do this, locate the button on the device. The exact location of the button will vary depending on the model of your device, but it is usually located in the bottom panel. It is hidden inside a small hole. You can identify the button by the “RESET” badge located near it.
Here are the steps to follow once you have found it.
- Hold the RESET button down for at least 10 seconds with a thin object such as a paperclip or pin.
- The LEDs on your front panel will start to flash after about 10 seconds. This is an indication to release the button.
- After that, the Linksys Velop router will reset itself. The process is still in progress. However, you should not turn off the router as this could cause damage to the hardware and software.
After the manual reset, you can access the internet again.
Use the Wizard for Web-Based Setup
You can use the web-based setup wizard to perform a number of functions on your Linksys Velop router. You can also use it to perform device resets.
Before you start the RESET process with the web-setup wizard you need to make sure that your computer is connected to the local network. Simply put, you need to connect the Linksys Velop router to the computer system that you will be using to access the web-based setup page. You won’t have access to the setup wizard if you don’t.
When you’re ready, follow the instructions below.
- Navigate to the web-based setup page using a web browser. Then, go to the “Device Administration” section.
- After that, select the “Reset Device” option. After clicking the button, you might be asked to enter your admin password. If you do not have an admin password, please leave it blank and click the “Submit” button.
- Then, click on the “RESET router” button.
Your Linksys Velop router will now be restored to factory default settings. Moreover, you can now read our blogs to learn more about the setup of your Linksys Velop router.
Need more help with Linksys Velop reset? Connect with us today!